These O-rings can be inserted on your 1911 grip screws and help them from shooting lose by filling voids and applying tension from the rubber under load. These units will likely be single use - they wear each time the screw is torque down so that...

These are high quality, high reliability magazines for Armscor Rock Island Armory (RIA) High Capacity 2011-style 10mm and .40 S&W pistols. Specfically, these are for the A2 HC pistols that use the 16 round double stack magazines and are...

These are high quality, high reliability magazines for Armscor Rock Island Armory (RIA) High Capacity 2011-style 10mm and .40 S&W pistols. Specfically, these are for the A2 HC pistols that use the 16 round double stack magazines and are...

An increasing number of 1911 and 2011-style pistols are using a full length guide rod that requires the insertion if a pin to capture the reverse plug during disassembly. While some guys will fashion a pin from a paper clip, our solution is more...

These are high quality, high reliability magazines for Armscor Rock Island Armory (RIA) High Capacity 2011-style 10mm and .40 S&W pistols. Specfically, these are for the A2 HC pistols that use the 16 round double stack magazines and are...

These are original magazine springs removed from Act-Mag brand 15 round .40/10mm staggered magazines. These are the magazines sold by / included with Rock Island Armory A2 HC .40 S&W and 10mm pistols. They were removed from magazines that we...

These are extended 10% plus mag springs for Arredondo followers and extended base pads. Note, you would need to bend the top end of the spring to fit any follower other than Arredondo. These springs are manufactured for Arredondo Accessories by...

This magazine follower is designed for competition which means it is reliable but it does not lock the slide open. If you look at the photos, you'll notice the "shelf" that normally pushes the slide lock open is angled down such that it will not...

These base plates are CNC machined from billet aluminum and allow for positively seating Para/RIA style magazines in pistols that have mag well funnels. These black base plates are 0.100" taller than the traditional steel Para magazine plate and...

These base plates are CNC machined from billet aluminum and allow for positively seating Para/RIA style magazines in pistols that have mag well funnels. These black base plates are 0.200" taller than the traditional steel Para magazine plate and...

These base plates are CNC machined from billet aluminum and allow for positively seating Para/RIA style magazines in pistols that have mag well funnels. These black base plates are 0.100" taller than the traditional steel Para magazine plate and...

When you have multiple magazines, it is a good practice to label them so if you have a problem at the range, you know which one to work on. In addition, by numbering your mags, you can try adjusting or tuning them and keep track of performance....