This is a high-strength 12.9 alloy screw for grips that have at least a 1/2"countersink. It follows the normal 6mmx1.0mm pitch x 100mm dimensions and has an oversize 12mm head that uses a hex key. This screw will work on all of our grips unless...

After many requests, we now have our version of the next generation Bulgarian Grip that is used on the AR-M12F, AR-M8F, AR-M4SF, AR-M1F41 and AR-M9 rifles (among others) with the original selector notch! We offer a custom version with the notch...

This is our US-made black solid cast version of the grip used on the IMI Galil rifles. There is a dimple marking the hole for the cross pin *if* you need to drill it for your particular rifle. Because not all Galil variants used the cross pin, we...

This is our version of the second generation Polish Beryl grip. It is ambidextrous and ergonomic. It is our solid cast body that is then drilled out for mounting to an AKM. I'm not sure if it will fit the grip strap on a Yugo out of the box but...

This is our version of the new Russian AK-12 grip and includes the screw. It is colored black and has our blasted finish plus it comes with a screw. Unlike the hollow original, our grip is cast as a solid block and is drilled out - it does not...

I had a custom screw shop make the bolts needed to secure the wood fixed butt stocks on Yugoslav / Zastava military M70, M72 and M76 rifles. It is an 8mm diameter bolt with a 1.0mm pitch and is 260mm (10.24") long just like the original. These...

This is our Yugo M72B1 RPK handguard set ( both the lower and the upper ). It is cast in our high-temp glass fiber reinforced plastic and it will not require a ferrule because the M72 ferrules are unique, you will not find them anywhere and our...

Guys have asked us over and over for a cost effective replacement to the Yugo recoil pad screws and now we have them. They are not identical to the originals in terms of the thread but once installed, they look the same from the outside and they...

These are custom made Yugo/Zastava-style grip screws with the big flat head and a lock washer. These are the standard 6mm thread diameter, 1.0mm pitch and approximately 100mm long -- about 96mm shaft and a 3.5-4mm thick head. These were used in...

These are replicas of the Yugo ferrules for the M70, M77, M85 and M92 rifles that we have made for us here in Michigan and are finished with a nice rich black oxide finish. I am unaware of any other country's rifle / model of AK that these will...

Found on the M70 and M72 family of Yugoslavian AKs as well as the M85 and M92 rifles. Used by both stamped and milled versions, it is one of the most ergonomic grips - especially given its size. Please note we only offer this grip in black with a...

The military-sized recoil pad we sell will not fit the current PAP M70 buttstocks that have a steel butt plate. This is a replica recoil pad for the military M70, M72 and M76 fixed stock rifles. It is cast from originals and has the same...

Tired of loose Yugo M85, M92 or PAP pistol handguards? We are pleased to now offer solid steel shims so you can finally get the tight solid fit with your lower handguard that you have wanted. These shims are specifically for the M85, M92 and PAP...