This is an H1 buffer for the AR/M4 carbine rifles and pistols that use buffer length tubes,  It uses tungsten weights and weighs approximately 3.9oz

This is Mil-Spec sized.

Made in the USA!

This is an H2 buffer for the AR/M4 carbine rifles and pistols that use buffer length tubes,  It uses tungsten weights and weighs approximately 4.7oz

This is Mil-Spec sized.

Made in the USA!

This is an H3 buffer for the AR/M4 carbine rifles and pistols that use buffer length tubes,  It uses tungsten weights and weighs approximately 5.4oz

This is Mil-Spec sized.

Made in the USA!

Mil-Spec replacement part for the ejector and safety selector detent spring for AR-15 and M4 rifles/pistols.

This extended model replaces the original mag release button and protrudges slightly more making it easier to find and push. The surface is knurled as well. It screws on just like the original but has a closed top so you thread it on until the...

This pin set includes both the rear takedown and front pivot pins.  They are CNC machined from steel and have extended heads/knobs to allow for easier gripping to pull them open. 

Made in the USA!

This is a Mil-Spec magazine release spring for AR-15 and LR-308 type rifles and pistols.

Made in the USA.

This is a Mil-Spec magazine release button that will fit AR-15 and LR-308 type rifles and pistols.

Made in the USA.

This is a Mil-Spec receiver end plate that orients the buffer tube vertically for AR-15/M4 and LR-308 carbines and pistols.

Made in the USA!

This is a Mil-Spec steel "castle nut" for locking the AR/M4 carbine's receiver extension/buffer tube in place.

Made in the USA!

This is a Mil-Spec safety selector - sometimes called the selector switch or selector lever.  It will fit AR-15, AR-10 and LR-308 type rifles and pistols.

Made in the USA.

This is a Mil-Spec detent that goes on top of the safety selector spring on AR-15 and LR-308 type rifles and pistols.

Made in the USA!