This is a heavy duty 1/2" stainless steel split ring that is black oxide finished.  It can be installed on any of our quick takedown pins if you want a ring smaller than the standard 1" ring that comes with the pins.

This new flat head pin replaces the dust cover hinge pin on the Zastava / Yugoslavian M85/M92 rifles and the corresponding Zastava PAP pistols to allow for rapid removal and does not have a pull ring - we have a model that does have the ring is...

This new flat head pin replaces the dust cover hinge pin on the Zastava / Yugoslavian M85/M92 rifles and the corresponding Zastava PAP pistols to allow for rapid removal and does not have a pull ring - we have a model that does have the ring is...

This is a heavy duty 3/4" stainless steel split ring that is black oxide finished.  It can be installed on any of our quick takedown pins if you want a ring smaller than the standard 1" ring that comes with the pins.

This is a high-strength 12.9 alloy screw for grips that have at least a 1/2"countersink. It follows the normal 6mmx1.0mm pitch x 100mm dimensions and has an oversize 12mm head that uses a hex key. This screw will work on all of our grips unless...

These are the best AK fire control group retainer plates I have found bar none and use them in my AKs. In many cases, the other vendors did plates that were too thin and this let the pins move around. Our plate is made from 304 stainless and is...

If you have ever tried to assemble an AK and install the trigger, you know how challenging it can be to keep the disconnector and spring assembly properly aligned while sliding in the trigger pin. We have a far simpler solution for you. We've...

Does having your krink's dust cover in the way when you are working on your weapon drive you nuts? If it does, you are like me. I have a Yugo M92 and developed a quick release pin for it. We found that the pin was too long for Bulgarian and Tula...

This is a 14mm steel crush washer. It's most common use is on 7.62x39 AKs as well as other rifles and pistols. Pricing is per washer and there are volume discounts. Approximate dimensions: Inner diameter: 14.66mm Outer diameter: 20.75mm Crush...

This quick takedown pin will work on either the Kashnikov USA KP-9 or the PSA AK-V. The design comes in handy for cleaning or other times you want clear access into the receiver without the dust cover being in the way. The pin is the same...

This is for two pairs (meaning two screws and two nuts) of quality stainless T-Nuts and Screws for M-Lok attachment points. The screw head measures 0.3" Length of thread is 0.38" T-nut width is 0.43" T-nut height is 0.2" The stainless screw comes...

This pin replaces the dust cover hinge pin on the Vepr 12 to allow for rapid removal. The design comes in handy for cleaning or other times you want clear access into the receiver without the dust cover being in the way. The pin is the same...